In today’s society saving money is everything. In the midst of a recession people are beginning to do jobs that they would normally save for a plumber or handyman. However, for today’s consumer that can mean a lot of money out of pocket. Therefore, I will go over the steps you can take to install your very own Clawfoot bathtub.
Materials you will need in order to install your Clawfoot bathtub are as follows:
- Channel Locks for attaching nuts and bolts to the feet
- Hacksaw for trimming
- Pipe Wrench
- PVC Piping
- PVC glue or primer
- Pipe coupler
- Bathtub Drain
- Supply Line to the Clawfoot tub
- Clawfoot bathtub fixture
- Some type of enclosure for where you will be putting the tub
Before you decide to bring your Clawfoot bathtub into the bathroom there are a few things that you must do beforehand. First, use your hacksaw to cut holes in the drywall. You will want to do this in the wall and ceiling near where you intend on placing your Clawfoot tub. Next, push the PVC pipe through the hole you just made in the floor. Make sure it connects to the higher opening. You can then use your PVC glue to attach the pipe coupler, which connects the Clawfoot bath pipes to the ones in your wall. Go ahead and turn of the main water supply, clean the area, and bring in your Clawfoot tub.
Now that you have got your Clawfoot bathtub in place, you can begin to attach your Clawfoot bathtub fixtures. Before you do this you want to make sure all of your plumbing is in place. If all the plumbing seems to be in order then you can go ahead and connect your Clawfoot tub fixtures to the cold and hot water pipes. You can connect your Clawfoot bathtub fixtures by using elbows and pipe sections. Next, you will want to fit your Clawfoot bathtub drain gasket and waste line. This can be accomplished by using your PVC glue for the line and a wrench to finish tightening down your gasket. Don’t forget to screw in the strainer cap.
The last thing you want to check is bathtub drainage. You must attach the drainpipe to the overflow hole and lock it in place with the retainer. Then you will want to make sure your tub drain does connect to the floor drain. Also, don’t forget to make sure you have a P-trap installed already. Lastly, check the plumbing for leaks and make sure all the compression fittings are tight. You are now ready to turn on your water and do one last look over your tub.
Installing a Clawfoot tub with fixtures can be a difficult task. With good manufacturer’s instruction and this installation guide, you might be able to get the job done and save some money. If you are uncomfortable about the installing the plumbing, you may get a local plumber to stub in the plumbing only. This could be a great way to save some money. You would then finish the actual installation of the Clawfoot bathtub or fixtures. It is advised to seek a plumber’s assistance if you are very skeptical about your abilities for installing your Clawfoot tub and fixtures. Good luck and enjoy your unique and stylish Clawfoot bathtub and fixtures. For more information please visit https://www.classicclawfoottubs.com.